My technique was slower, but his was much messier because of all the hot steam. However, he used so much steam that the water dripped down between the baseboard and wall, and onto the concrete walls in the basement below, and he had to paint those walls to cover the streaks after he was done. He steamed it much more and was able to get both layers of paper to break loose fairly quickly. Do not leave the steamer on longer than 30 seconds at a time the plaster can crack if left on too long. I then hired a guy to strip my living room wall and his technique was different. Removing wallpaper from plaster walls is best achieved using a wallpaper steamer. Before drywall became the go-to for modern homes, plaster walls were everywhere. The process has largely been abandoned in favor of drywall. Therefore, if you really want to replace your lath and plaster walls with drywall, then you need to remove the plaster walls completely down to the studs. A finished drywall wall ready for painting. There are three different layers: the scratch coat, the brown coat, and the veneer coat. Your only insulation option is going to be blown-in insulation. With millions of inspiring photos from design professionals, youll find just want you need to turn your house into your dream home. Step 1: Check Bottom Edge a corner seam the bottom the wall, a putty knife pry edge the wallcovering. Start the loose and gently pry wallpaper and away. Browse through the largest collection of home design ideas for every room in your home. Scrape Wallpaper Remove steamer quickly scraping the putty knife. This was a slow process, but I did get it all off. Lath and plaster was a popular method of plastering homes between 17. Showing Results for 'Lath And Plaster Walls'. I am right handed, so I held the steamer on one section with my left hand while I scraped paper off with my right hand and continued to work from right to left. I then used the steamer and a razor blade (in a holder) held at a very slight angle to strip off all the remains. I first stripped off whatever I could using the steamer and paper tiger, but there was still a lot of small sections left on the wall. Mine appeared to be patterned wallpaper on top of a white wallpaper-like finish that had been applied when the plaster was new. Now, drag it down to tear the plaster in a downward motion. Gently, place the claw end of the crowbar on the hole that you made just now. Then you will finally see the lath behind this plaster. Then I used a steamer and stripped off the larger pieces of wallpaper. Grab a crowbar or any hammer and start tapping the area until you create a hole, do this repeatedly until you see the lath beneath. I tried perforating the paper withe paper tiger and spraying the wall with remover, but in most areas it didn't really break the old paper loose and I just got small strips to come off. However, wallpaper that has been applied to raw plaster really sticks to it. Sheetrock has a paper layer on top, and if its painted before paper is applied, the wallpaper does not stick that tightly. Most of the info you find online is from folks who are stripping modern wallpaper off of sheetrock, and stripping very old wallpaper off of plaster may take a different technique.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |